Bookings from our Houston order log, written up step by step. We name the town, never the street. Most same-day calls are reached in 30 to 60 minutes, and booked jobs start inside the window. Every visit includes a wall scan before drilling, a vacuum at the bit, a laser level and a full cleanup before the technician leaves.
Six TVs in one Katy house, five on full-motion arms
The homeowner wanted every room done in one visit: a 40, a 43, a 50, a 65, a 75 and an 86-inch TV. Four of the six were going on full-motion arms so they could swing toward a sofa or a bed. The 86-inch needed two people to lift.
The technician pulled up 40 minutes after the confirmation call, with the four arms and the cord covers already loaded from the warehouse. Before drilling, the technician walked each room with the owner, marked the center height with painter's tape and scanned every spot for studs, plumbing and live wiring. Two of the walls backed onto bathrooms, so the pipe scan mattered. Full-motion arms carry the load on one point when extended, so each one went into two studs with lag bolts, never anchors alone.
Wires were run in paintable cord covers on five walls because the owner didn't want any drywall opened. Every screen was leveled after hanging, the arms were adjusted so they don't sag at full extension, and each TV was powered on and tested. Drill dust was vacuumed as the work went, and the packaging was bagged up before leaving.
Five screens and five in-wall runs in Crosby
This order mixed small and large screens: three 30-inch TVs on full-motion mounts, plus a 50-inch and an 80-inch on low-profile fixed mounts. The customer wanted no visible cords on any of them.
This one was booked two days ahead for an 8–10 a.m. window, and the van was in the driveway at 8:05. In-wall routing starts with the scan. The technician checked each cavity for a fire block, a water line or electrical cable between the TV and the outlet before cutting. Each run got a recessed plate behind the screen and a second plate near the floor, with the cable fished between them inside the wall.
The 80-inch went on last, with two people lifting. Its fixed mount was leveled with a laser before the bolts were fully tightened, because on a screen that wide a 1° tilt shows. The small full-motion arms were set so they fold flat when not in use. Every opening was trimmed clean, and all five screens were tested on their inputs.
Moving a 75" and a 98" to a new house in Cypress
A family moving within Cypress booked us to take down a 75-inch and a 98-inch TV at the old house and hang them at the new one. A 98-inch panel is too large and too flexible for one person, so two technicians were scheduled from the start.
The crew reached the old house at the start of the booked window and had both screens down within half an hour. At the old house the screens came off first, then the brackets. The technicians left the bolts loose until the TV was supported, so nothing twisted on the way down. The holes in the drywall were left clean for the owner's patching.
At the new house the walls were scanned again, because a new home means unknown stud spacing and plumbing. The 98-inch went on a heavy-duty bracket bolted into two studs, and it was lifted by both technicians at once. Both screens were leveled and tested, and the site was vacuumed.
Four TVs in Montgomery, one above the fireplace
This Lake Conroe-area home had four TVs to hang. The 65-inch was going over the living-room fireplace, the 80-inch on the main family-room wall, and two 55-inch sets in bedrooms. The owner wanted the cords hidden on three of them.
Montgomery is a long drive from central Houston, so the slot was set for the afternoon; the two technicians arrived at 1:10 for a 1–3 p.m. window. Above the fireplace, the technician first checked the wall temperature at the planned height and opened a small inspection hole to see the chase. The cavity was framed and clear, so the cables were fished inside it to a recessed outlet behind the screen.
The 80-inch needed two people. Before cutting the other two in-wall openings, the technician scanned for plumbing, wiring and blocking. Each bracket was leveled and torqued, and every set was powered up with its source connected. Dust from each cut was vacuumed right away.
Two TVs and two soundbars across two Houston addresses
The customer was moving from a Westchase home to a house in Memorial. They wanted the 65-inch and its soundbar taken down, carried over and re-hung, plus a 55-inch with its own soundbar at the new place.
The two technicians were at the Westchase address 35 minutes after the customer confirmed the time. At the first address the technicians removed the soundbar, then the TV, and wrapped the panel in bubble wrap for the drive. At the second, they scanned both walls for studs and pipes before marking the bracket position at the height the owner chose.
Each soundbar went on its own bracket centered under the screen, with a gap so the TV can tilt without hitting it. The audio was tested through HDMI ARC on both sets. Packaging and dust were cleaned up at both houses.
Five TVs and two recessed boxes in Pattison
A ranch property west of Katy, with an 85-inch for the main room, two 75-inch sets for the bedrooms, and two 55-inch Samsung Frames for the dining room and a hallway. The owner wanted the Frames to hang like art, so we brought recessed power boxes.
The technician arrived 50 minutes after booking with the recessed boxes and an extra set of Frame slim-mount screws. The house was newer construction with wood studs at 16 inches. The scanner flagged a vent duct in one of the bedroom walls, and the 75-inch moved one bay over to stay on solid framing.
For the two Frames, the recessed boxes were cut in with a vacuum-shrouded saw, and the One Connect cables were fished to cabinets. Both Frames were laser-leveled, because a picture-flat TV next to a door frame shows any tilt. The 85-inch went up last on a fixed mount with two people lifting.
Each TV was tested. The owner chose artwork for both Frames, and the floors in every room were vacuumed.
An 85" and a 55" with hidden wires in Richmond
A two-story in a Richmond master-planned community. The 85-inch went on a low-profile fixed mount in the family room with a soundbar from our stock, and the 55-inch in the game room upstairs. Both had the cables hidden inside the wall.
The technician reached the house 35 minutes after the call. In the family room, the scanner showed an electrical cable running horizontally at about 50 inches, right where the lower in-wall plate would go. He dropped the plate below it and fished the cable past, so there was no risk of nicking the line.
The 85-inch was lifted onto the bracket by two people. The soundbar was centered underneath with a finger-width gap, and ARC was tested with the TV remote. Upstairs, the second run was straight down one bay.
Both openings were trimmed with recessed plates, and the dust was vacuumed from both rooms.